Sandwich Panel Roll Forming Device, EPS Sandwich Panel Line, Mineral Wool Sandwich Panel line, Sandwich Panel Roll Forming Line

sandwich panel machine

Sandwich panel generation line is specifically created for making insulation composite board. With stepless speed regulation system, it is in a position to make corrugated composite panel proficiently at one time. Sandwich panel roll forming device has been an indispensable device in fabricating roof panels and wall panels in plants and warehouses, between other properties.

Functions

one. The motor power of the sandwich panel roll forming line is 4kw, and the production velocity reaches 6m/min. With the stepless speed regulation program, the efficiency of the roll forming line is optional within -6m/min.

2. When generating EPS sandwich panel, the velocity is generally controlled at 2-six m/min. It will be slightly reduce for generating rock wool board (relies upon on genuine requirements)

three. The composite panel creation line is equipped with K-nine glue metering pump, featuring reduced rotating pace and high precision. The glue is fed at a fee of .1-2. kg/min. It is managed by frequency converter.

4. The thickness of the composite panel the roll forming device can make is assorted from 50mm to 250mm. By altering the upper and lower rack, and the distance amongst the cutter holder and the material feeding rack, we can get sandwich boards with various thickness and technical specs.

5. Whole put in potential: 34KW total excess weight (including accessories): seventeen.5t.

6. Dimension of the panel roll forming machine: 12500 (16000 for rock wool boards) X2200X2800 the roll previous for 5 kind EPS sandwich panel adopts 23 rubber shafts and 160X80 square tubes with thickness of 6mm the roll former for 7 type composite rock wool panel employs forty five rubber shafts, and upper and lower impartial glue offer. It is outfitted with one.7m rock wool panel conveyor belt, with the diameter of the travel shaft to be 50mm length of the equipment body is up to 9m the roll previous is welded with 180X80 sq. tubes which thickness is 8mm.

Needs for Factories:

The factories the place our EPS sandwich panel production line are utilized can be either flatroof or sloped-roof variety. The peak of the cornice should be more substantial than 5m, and the effective width should be at the very least 45m. The ground of the manufacturing facility must be flat and concrete. For basis of the roll forming line, it is necessary to be to be 380V, and the whole mounted energy is 34kw. It is required for the manufacturing unit to be outfitted with .4-.6MPa compressed air provide and illumination devices. The roll forming machine shares the very same energy offer with the auxiliary units. The fluctuation of voltage need to be no a lot more than 10%, or it may possibly guide to an irregular working of the system.

Leave a Reply

Your email address will not be published. Required fields are marked *